| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| .010 black fiber? Any sources? http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=9564 |
Page 1 of 1 |
| Author: | LanceK [ Wed Nov 29, 2006 2:08 am ] |
| Post subject: | |
I check our sponsors and unless I missed it I see no single black fiber lines .010 thick. Thanks |
|
| Author: | JBreault [ Wed Nov 29, 2006 2:25 am ] |
| Post subject: | |
Lance, its not technically black fiber, but it may work...I found this source for fish paper. They sell it in various thicknesses (.010 being one). Fish Paper Vulcanized Fiber $35 for a sheet may be more than you want to spend, but a 2'x3' sheet will make a lot of purfling lines. |
|
| Author: | Kim [ Wed Nov 29, 2006 2:40 am ] |
| Post subject: | |
Lance, I think BobC has 10 thou in stock and is expecting 20 thou soon, have a look on the home page of his site. There ya go Cheers Kim |
|
| Author: | Bobc [ Wed Nov 29, 2006 2:43 am ] |
| Post subject: | |
Lance I have lot's of it. Let me know what you need. |
|
| Author: | Shane Neifer [ Wed Nov 29, 2006 3:00 am ] |
| Post subject: | |
Glad that Bob has it, I only have .020 and .030. Shane |
|
| Author: | MSpencer [ Wed Nov 29, 2006 6:11 am ] |
| Post subject: | |
Does anyone have it pre-cut in strips like StewMac? I see where most have sheets and precision cutting this thin stuff is pretty tough. Mike |
|
| Author: | Shane Neifer [ Wed Nov 29, 2006 6:32 am ] |
| Post subject: | |
Mike, I think both Bob and I, at least, have purfling lines pre-cut into thin strips. But I do also carry double length binding height purfs to place on the side of the binding channel rather than cutting a seperate purf channel, if you get want I mean. But I do have white, black, b/w/b, b/w/b/w, maple and pearwood in small purf size pieces, like .020 to .030 x .060 x 34.5 inches Hope that helps! Shane |
|
| Author: | Hank Mauel [ Wed Nov 29, 2006 2:09 pm ] |
| Post subject: | |
Gurian has almost anything you can think of in the purfling/binding arena. He has a $200 minimum, but if you want to build up a "stock" design for your main (spec)instruments, then buy individual "stock" for the "custom" builds, the minimum gets met pretty quickly. Check out the web site at: http://www.gurianinstruments.com/index.php |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|